| Assembly |
| |
19 Screw |
| 20 | Key Assembly |
|
| ||
Front Fairing |
|
| |
Peg | Screw | Knobs | Microphone |
|
| ||
| Peg |
|
|
Screw | Screw |
|
|
Tab |
|
| |
Tab |
|
| |
|
|
| |
Handlebar |
| • Bend the plastic tip at the end of the microphone cord so | |
| that it forms a "T". |
| |
Assembly |
| • Insert the plastic tip through the hole in the handlebar | |
|
| ||
|
| housing. |
|
|
| • Pull lightly on the microphone cord to make sure it is | |
|
| secure in the dash. |
|
• Fit the front fairing onto the handlebar assembly. Make | • Fit the tab on the back of the microphone into the hole in | ||
the center of the dash to hook it to the dash. | |||
sure that the screw tabs on the handlebar assembly are | • Snap the key assembly into the large hole in the dash. | ||
aligned with the screw pegs on the front fairing. |
| ||
| • Snap the radio knobs into the holes in the dash. | ||
• Insert four #8 x 3/4" screws through the top half |
| ||
| 21 |
| |
of the handlebar housing and into the front fairing and |
| ||
tighten the screws with a Phillips screwdriver. Do not |
| ||
|
| ||
• Insert two #8 x 3/4" screws up through the bottom half of |
| ||
the handlebar housing and into the front fairing and |
|
| |
tighten the screws with a Phillips screwdriver. |
|
| Right Hand Grip |
Do not |
|
| |
|
|
| |
Helpful Hint: You may want to use a long screwdriver to |
|
| |
tighten the screws going into the bottom half of the |
|
|
|
handlebar housing. |
|
|
|
|
|
| Soundbox Stem |
|
| Note: The left and right handgrips are not interchangeable! | |
|
| The hole in the left handgrip is smaller than the hole in the | |
|
| right handgrip. |
|
|
| • Fit the right hand grip onto the soundbox stem on the | |
|
| right side of the handlebar. If it is difficult to slide the | |
|
| hand grip onto the soundbox stem, moisten the hand grip. | |
|
| • Repeat this procedure to fit the left handgrip onto the | |
|
| left side of the handlebar. |
|
14