Assembly
12
Hole
Hole
Circular
Indentation
14 |
| Steering |
| Column | |
|
| |
| Lower | Upper |
| Steering | |
| Steering | |
| Linkage | |
| Linkage | |
|
|
Lock Nut 
Handlebar
Lock Nut
Neck
•Position the handlebar so that the side with the three holes and circular indentation faces up.
•Fit the neck against the bottom of the handlebar, with the holes in the handlebar and neck aligned.
•Insert a 11/2" screw down through each of the two outer holes in the handlebar and then through the neck.
•Fit a lock nut on the end of each screw.
•Using pliers to steady the lock nuts, tighten each screw with a Phillips screwdriver. Do not
13 | Sound |
Handlebar | Box |
Neck |
|
•Position the handlebar with the neck facing down and the handlebar curving toward you.
•Slide the soundbox onto the right end of the handlebar, soundbox side first.
•Set the handlebar assembly aside.
Hole |
•Lift the front end of the vehicle.
•Slide the straight end of the steering column through the hole in the upper steering linkage and out through the hole in the vehicle body.
•Insert the curved end of the steering column into the hole in the lower steering linkage.
15 |
Steering |
Column |
Cap Nut |
•Fit a cap nut on the curved end of the steering column.
•Support the steering column and tap the cap nut with a hammer to secure it on the end of the steering column.
•Position the vehicle body upright.
12