F | Assembly | |
| ||
1 | 3 | |
| Round Hole | |
| Rear Axle | |
Right Fender | Right | |
Mudflap | ||
| ||
Peg |
| |
| Bottom View | |
| Cap Nut |
• Position the vehicle body upside down.
Note: The mudflaps are marked “R” and “L” to designate right and left.
•With the “R” marking facing up, align the two round holes in the right mudflap with the pegs on the underside of the right fender.
•Insert two #8 x 3/4" screws through the round holes in the mudflap and into the right fender.
•Tighten the screws with a Phillips screwdriver. Do not
2 |
Oval Hole |
Right |
Mudflap |
Bottom View |
•Align the two oval holes in the right mudflap with the pegs on the underside of the right fender.
•Insert two #8 x 3/4" screws through the oval holes in the mudflap and into the right fender.
•Tighten the screws with a Phillips screwdriver. Do not
•Repeat steps 1 and 2 to assemble the left mudflap (“L”) to the left fender.
•Fit a cap nut onto one end of the rear axle.
•Tap the other end of the rear axle with a hammer to secure the cap nut on the end of the rear axle.
Note: You may want to position the cap nut on a scrap block of wood to protect the assembly surface.
4 | Washer |
| |
| Rear Wheel Driver |
Wheel
Hex Bushing
Hubcap
•Slide a hubcap, inside surface up, onto the rear axle.
•Slide a hex bushing, ring side first, onto the rear axle.
•Slide a wheel onto the rear axle. Make sure the ribs on the wheel face up.
•Slide a rear wheel driver, ring side first, onto the rear axle. Fit the grooves on the rear wheel driver onto the ribs on the wheel.
•Slide a washer onto the rear wheel axle.
•Set the rear axle assembly aside.
9