SECTION 5: SERVICE PROCEDURES
WASH TANK HEATER REPLACEMENT (CONTINUED)
6.Next, use the ratchet and 1/2” socket to remove the heater mounting nuts.
Removing upper (wash) strainer.
Removing the heater nuts.
5.Using the 3/8” nutdriver, remove the nuts securing the heater wires to the heater. Then carefully pull the wires out of
the way. Using the ratchet to remove the heater mounting nuts.
Reaching into the wash tank.
7.Removing the heater may require that you reach into the wash tank, grasp it and give it a push out of the wash tank.
Pulling the heater out.
8.Once the heater is pushed away from the tank wall, pull it out with your hands.
9.Remove the old heater gasket and throw away.
10.Apply the new heater gasket.
11.Take the new heater and slide it through the hole in the wash tank and line it up so the wash tank studs fit in the holes on the heater flange.
12.Place the mounting nuts and lockwashers on the studs and secure them with the ratchet and 1/2” socket.
13.Place the heater wires on the heater and tighten them down using the 3/8” nutdriver.
Delta 1200 Technical Manual
Issued:
21