Jackson Chemical Sanitizing Glasswasher Dishmachine Series, Delta 1200 Specification Information

Page 7

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS

Delta 1200

 

OPERATING CAPACITY (RACKS/HOUR)

 

GLASSES PER HOUR

1200

OPERATING CYCLE (SECONDS)

 

TOTAL CYCLE TIME

120

TANK CAPACITY (GALLONS)

3.0

WASH PUMP CAPACITY

 

WASH PUMP

55 GPM

TEMPERATURES

 

WASH---°F (MINIMUM)

130

RINSE---°F (MINIMUM)

75

ELECTRICAL REQUIREMENTS

 

WASH PUMP MOTOR HORSEPOWER

1/10

NOTE: Typical Electrical Circuit is based upon (1) 125% of the full amperage load of the machine and (2) typical fixed- trip circuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than what is displayed here. Always verify with your electrical service contractor that your circuit protection is adequate and meets all applicable national and local codes. These numbers are provided in this manual simply for reference and may change without notice at any given time.

 

 

 

RINSE

 

TYPICAL

 

 

 

HEATER

TOTAL

ELECTRICAL

VOLTS

PH

HZ

RATINGS

AMPS

CIRCUIT

208

1

60

220V/3KW

15A

15A

230

1

60

220V/3KW

15A

15A

WATER REQUIREMENTS

 

 

INLET TEMPERATURE

 

130°F

GALLONS PER HOUR

 

10.0

WATER LINE SIZE NPT (Minimum)

 

1/2”

DRAIN LINE SIZE NPT (Minimum)

 

1-1/2”

FLOW PRESSURE P.S.I.

 

205

MINIMUM CHLORINE REQUIRED (PPM)

50

MINIMUM IODIPHOR REQUIRED (PPM)

12.5

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

Delta 1200 Technical Manual 07610-003-62-15 G

Issued: 10-27-2008 Revised:05-21-2012

2

Image 7
Contents For Jackson Models Technical ManualPage Revision Made Applicable Details Date ECN Nomenclature for the Models Covered in this Manual Glasswasher SeriesTable of Contents Section Specification Information Specification Information Section B-B Machine DimensionsSection INSTALLATION/OPERATION Instructions Installation Instructions INSTALLATION/OPERATION InstructionsElectrical Connections Detergent Control Priming Chemical Feeder Pumps Chemical Dispensing Equipment To Prepare Pumps for OperationOperating Instructions To Fill Machine with Water Shutdown and Cleaning of the MachineTo RUN the Machine Section Preventative Maintenance Preventative Maintenance Preventative MaintenanceSection Troubleshooting Common Problems TroubleshootingUSE Extreme Caution When Testing the Machine Problem Low wash water pressure at wash arm spray nozzles Problem Rinse aid pump not feeding, detergent feeds okay Section Service Procedures Time Required Service ProceduresPreparation Tools RequiredPulling the rubber tube out of the pump Special Notes After Maintenance ActionsSpecial Parts Wash Tank Heater Replacement Removing upper wash strainer Removing the heater nuts Removing the heater gasket Thermostat Replacement None Wash Motor Replacement Service ProceduresCombination wrench After Maintenance Actions Section Parts Section Parts Section Control BOX AssemblyQTY Parts SectionOuter Shell Outer Shell AssemblyParts Section Chemical Feeder Pump Assembly Parts Section Rinse Assembly Wash Assembly Wash System Wash and Fill SystemParts Section Conveyor Drive System Conveyor and Drive SystemParts Section Door Assembly Parts Section Section Electrical Schematics Electrical Schematics