Powering the Digital Video
Loading the Battery
3.7V Rechargeable
1. Open the battery cover by sliding it in the direction shown.
2. Load the battery and close the battery cover.
How to recharge the battery
zUse the AC Adapter to recharge the battery.
Turn off the Digital Video, then connect the AC Adapter cable to (DC IN) jack of the DV, and insert the power plug into a power outlet. The battery will be recharged through AC Adapter.
zUse the USB to recharge the battery.
Turn off the Digital Video, then connect the Digital Video to PC, the battery will be recharged through the USB cable.
Note
zUse only specified 3.7V rechargeable
zWhen the battery symbol is (near end), it indicates that the batteries
are nearly exhausted. Be sure to have spare batteries on hand.
zNOT ALL BATTERIES ARE THE SAME! Battery life depends significantly on battery age, usage conditions, type, and brand.
zBattery performance is reduced at temperatures below 41 °F (5 °C).
Note for Recharging Battery
1.LED Status: (A)during recharging, the LED is red, (B) LED is not lit when charging has been completed, (C) if under voltage, the LED is green, (D) if the battery temperature is abnormal the LED is orange (if, without battery, use the AC Adapter as the power source , the LED is also orange, but it is normal).
2.For LED status (C), please change the battery.
3.For LED status (D), please disconnect the AC Adaptor and remove the
E16 | battery, wait until the battery cools down and try again. |