Concord Camera 5062AF manual Restore the Camera to Factory Default Settings, Option Default Status

RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS

RESTORE THE CAMERA TO FACTORY DEFAULT SETTINGS

To restore the default settings in your camera:

1.Press when Restore Default is highlighted in the camera.

2.Press or to select No or Yes.

•When No is selected, no change is made. The LCD returns to the previous screen.

•When Yes is selected, the LCD shows “Are you sure?”

3.Press or to select Yes or No.

•If No is selected, no change will be made. The LCD returns Setup page.

•If Yes is selected, the camera will be reset to the factory default setting. The LCD will show “Restoring...” for a few seconds and then return to setup page. The Default settings will be restored.

Note: Please refer to the table below for the default settings.

OPTION	DEFAULT STATUS
Camera Mode	Single Shot
Image Size	2560 x 1920 (Concord Eye-Q 5062 AF); 2272 x 1704 ( Concord Eye-Q 4062 AF)
Quality	Normal
Flash	Auto Flash
White Balance	Auto
LCD Brightness	Center (0)
Scene Selection	OFF
Exposure Compensation	0
ISO	Auto
Metering	Matrix
Photo Effect	None
Time Out	2 min
Slide Show Interval	2 Seconds
Beep	ON
Quick View	1 Sec
AF Mode	Multi-Area
Continuous Repeat	No
AF Assist Light	Auto
TV Mode	NTSC for USA/Japan, PAL for Europe/Asia
Date/Time Format	USA/Japan: MM/DD/YYYY, 12-hour
	Europe/Asia: DD/MM/YYYY, 24-hour

En

44