System Interconnections, Installation | Acclaim Lighting A5000

SYSTEM INTERCONNECTIONS

A5000 Acclaim System - The diagram below shows the possible interconnections of the A5000 Acclaim System using the A5050 Control Module (without internal capture card). The heavy solid

connection lines designate the typical operating configuration (connected to a computer system). The dashed line shows the optional connection to a video monitor, while the lighter solid connection lines show camera and power connections common to all system setups. Connect the A5000 System as required by individual office equipment .

A5000 System Interconnection

	USB 2.0
PC	HIGH SPEED VIDEO
PC
COMPUTER	PC GAME PORT
	PC GAME PORT
	CONTROL
Video
Capture Card	S-VIDEO OR	A5050


	COMPOSITE	CONTROL
	VIDEO	MODULE
VIDEO	See Note	MODULE
	See Note

MONITOR

AC	POWER	12 VDC POWER
AC	SUPPLY	12 VDC POWER
INPUT	SUPPLY
POWER	ADAPTER

	Typical Connections
	Optional Connections
15-Foot	Required Connections
Multi-Conductor
Cable
	CAMERA
	HANDPIECE
	A5020

BOTTOMTOP

BUTTON BUTTON

Note: S-Video and Composite Video cables can be connected to either a PC computer with capture card or video monitor as required by individual office equipment.

INSTALLATION

Installing the Acclaim Camera System is as simple as deciding where to place the Control Module and making the necessary cable connections to a video monitor and/or a PC loaded with an Air Techniques Authorized DirectX 9 compliant user-supplied streaming video software application. Perform the following procedures to install the Acclaim Camera System.

Control Module Location - Locate the Acclaim Control Module on a table top, cart or any flat stable surface convenient to an AC wall outlet and associated computer system/monitor. Make sure that the selected location allows easy access to front and rear panel controls and connectors.

USE CARE WHEN ADHERING THE DUAL LOCK FASTENER TO SELECTED

SURFACE. THE ADHESIVE FASTENS QUICKLY AND PERMANENTLY.

Control Module Hanging Option - The Control Module can also be installed hanging under a table top, under the chair or on the computer using the supplied Dual Lock Fastener Kit P/N A5155. Refer to the instruction sheet provided with the Dual Lock Fastener Kit for procedures to apply the fastener to the Control Module when using the hanging option.