INFECTION CONTROL SHEATH
MAKE SURE TO USE A NEW DISPOSABLE INFECTION CONTROL
SHEATH (PN A5123) FOR EACH PATIENT.
NOTE: For optimum image clarity, the optically clear section of the sheath must be aligned with the camera lens by facing the camera/lightsource section of the handpiece down toward the paper layer.
Disposable Sheath Installation - Install a new infection control sheath on the Camera Handpiece for each patient as follows:
1.Remove the Camera Handpiece from the holder.
2.Insert the Camera Handpiece tip between the second and third layers (between the outer paper and plastic layers) with the camera/light facing towards the paper layer. See A.
3.Push the Camera Handpiece completely in until the tip is fully inserted into the narrow tip of the sheath. See B.
4.Gently squeeze the illuminated tip of the Camera Handpiece between the thumb and index finger to ensure that the optically clear area of the sheath is flat against the lens tip. See C.
5.Peel away and discard the top plastic layer and the bottom paper layer. See D.
ACTIVATION
NOTE: Depending on the setup of the associated Acclaim Camera System, power turn on for each system configuration varies.
When all components share a single power source, turn ON that power source first.
When all components are plugged into a power strip with an ON/OFF switch, place the power strip switch to the ON position. Verify that the light on the ON/OFF switch illuminates.
When components are plugged into separate wall outlets, make sure power is available at each outlet.
Power Turn On - Perform the following procedure as necessary to turn the power on for operation of the Acclaim Camera System.
1.Review the Installation Section as necessary and make sure that the Acclaim Camera System components are setup and connected for the applicable operating configuration.
2.If not connecting to a computer system, proceed to step 3. When connecting to a computer system, turn on the computer and verify that the applicable video capture software and camera drivers are installed.
3.On the connected video monitor, turn on the Power switch and verify operation.
4.On the associated Control Module front panel, set the STANDBY/ON switch to the ON position and verify that the Control Module front panel LED indicator lamp lights.
5.Verify that the camera turns on and live video is displayed on the associated monitor when the handpiece is removed from the Handpiece Holder.
6.Verify that the camera turns off when the handpiece is returned to the Handpiece Holder.
17