Acclaim Lighting A5000 manual At an extra cost, A5050 Control Module/Camera Connection

INSTALLATION

DO NOT TWIST OR TURN THE CABLE CONNECTORS. EACH CONNECTOR IS

KEYED AND MATES STRAIGHT ON WITH ASSOCIATED DEVICE CONNECTOR.

NOTE:	In addition to the supplied 15-foot multi-conductor cable, optional 6, 9, 30
	and 50-foot lengths are available from your authorized Air Techniques Dealer
	at an extra cost.

Camera Handpiece Connection - Carefully connect the supplied Camera Handpiece Cable between the Camera Handpiece and Control Module as follows:

1.Using the gray molded connector cable end, align the connector key with the keyway of the Handpiece connector.

2.Insert straight into Handpiece connector until it securely snaps into place.

3.Using the 10-pin quick disconnect plug end, align connector key with the keyway of the mating CAMERA connector located on the front panel of the Control Module.

4.Insert the connector straight into the mating CAMERA connector until it securely snaps into place.

Camera Handpiece Connection

CONNECTOR KEY

CAMERA HANDPIECE

HANDPIECE CABLE

10-PIN QUICK

DISCONNECT PLUG

A5050 Control Module/Camera Connection

USE CARE WHEN ADHERING THE HANDPIECE HOLDER TO SELECTED SURFACE.

THE DOUBLE-SIDED ADHESIVE FASTENS QUICKLY AND PERMANENTLY.

Handpiece Holder Installation - Remove the protective film from the double-sided adhesive on the Handpiece Holder and attach the Holder to a flat, clean dry surface where the Camera Handpiece will be located.

11