To configure the alarm input channels:
1.From the Setup menu, click the Linking submenu.
2.Click Alarm.
3.Click the Input Type box, and select the alarm state.
4.Click the Camera box, and select the desired channel.
5.Configure the remaining settings.
6.Repeat the previous steps (as necessary) to configure additional channels.
7.Click Close.
8.Click OK.
MOTION
The unit allows you to configure the following settings:
•Channel: Selects the motion channel (CH 01 to CH 16) for configuration.
•Sensitivity: Sets the motion sensitivity (OFF or 01 to 10). Select a lower value to decrease the sensitivity to motion; increase the value to increase the sensitivity to motion.
NOTE: If sensitivity is set too low, the unit may not record a motion event. If sensitivity is set too high, the unit may record false motion events.
•Relay Output: Sets the relay output: NONE, O1, 02, 03, or 04.
•Area: Allows you to configure the motion area.
To configure the motion channel:
1.From the Linking menu, click the Motion submenu.
2.Click the Motion Channel box, and select a channel.
3.Configure the remaining settings.
4.Drag the motion grid to set the motion area.
5.Repeat the previous steps (as necessary) to configure additional channels.
6.Click Close.
7.Click OK.
50 | C4655M (2/11) |