NOTIFICATION
The unit allows you to configure the following settings:
•Alarm On: Sends a
•Motion Detection: Sends a
•Text In: Sends a
•Admin Password Changed: Sends an administrator 01 ID notification in response to a change to the 01 ID administrator password. Changing the password of additional users who are assigned
•Video Loss: Sends a video loss notification in response to a video loss event detected on any channel.
•Power On/Off: Sends a power loss notification in response to the server power being turned off.
•Disk full: Has the following guidelines based on the Hard Disk Overwrite setting at the server:
–ALL: A disk full notification is not sent because the server does not issue a disk full warning. When the normal and event partitions are full, the server continues to record video by writing over previously recorded data (oldest recorded data is overwritten first).
–OFF: Sends a disk full
–NORMAL: Sends a disk full
–EVENT: Sends a disk full
To configure the Notification feature:
1.From the Linking menu, click the Notification submenu.
2.Click the box for each event for which you want a notification sent.
3.Click Close.
4.Click OK.
The mail feature sends an
The mail feature is configured and operates independently of the emergency agent feature. For information about setting up the emergency notification feature, refer to Emergency Notification Setup on page 53.
The unit allows you to configure the following settings:
•Notification: Enables or disables the notification feature.
•SMTP Server: Enter the Simple Mail Transfer Protocol (SMTP) server IP address or host name. Supports up to 24 characters including 0.0.0.0 to 255.255.255.255, a to z, A to Z, numerals 0 to 9, and special characters.
•SMTP Port No: Enter the SMTP port. The default TCP/IP port used for SMTP is 25. Supported values are 25 and 1025 to 65535.
•User Name: Name of the user to be notified. Supports up to 24 characters including 0.0.0.0 to 255.255.255.255, a to z, A to Z, numerals 0 to 9, and special characters.
•Password: User password. Supports up to 24 characters including a to z, A to Z, numerals 0 to 9, and special characters.
•TLS: Select ON to use the Transport Layer Security (TLS) feature. By default, TLS is not enabled.
•Mail Address (1 to 3): User’s
•SMTP Server Test: Allows you to send a test
NOTE: The SMTP server IP address, port number, user name, and password are optional settings. The HVR can send
52 | C4655M (2/11) |