RESET BUTTON
The reset button is located at the top of the front panel. Using a probe or paper clip, press the reset button to reboot the EDI5000 as follows:
•Reboot the EDI5000: Press and immediately release the reset button to reboot the EDI5000.
•Reset to factory default settings: Press and hold the reset button for five seconds to reboot the EDI5000 with factory default settings.
NOTE: When the EDI5000 resets to factory default settings, the IP address reverts to the default address (192.168.0.1). If the EDI5000 is installed on a private network, it may no longer be accessible from the network after rebooting.
VIEWING VIDEO
If you have not already done so, install the matrix keyboard, connect it to the matrix system, and then complete the basic setup process.
To view video, complete the following steps:
1.From the matrix system keyboard select a monitor connected to the matrix system.
2.Select the number of the camera that you want to view. The type of video displayed for that camera depends on the following:
•If the camera number corresponds to a matrix system camera, live video from that camera appears on the monitor.
•If the camera number corresponds to a matrix system camera and the toggle command is used, recorded video appears on the monitor. This recorded video is received from a DVR/NVR recorder in the Endura system but the video itself originates from a matrix system camera. (Refer to the (Design and product specifications subject to change without notice. on page 41 for detailed information on operating the specific EDI5000 model.)
•If the camera number corresponds to a logical camera number from the Endura system, video from the Endura system camera appears on the monitor. Video from an Endura system camera is either live video from the camera or recorded video from an Endura system DVR/NVR, depending on the Live On Switch and Display Mode settings configured in the EDI5000 system configuration software (as described in Configure the Data Interface Settings on page 22).
3.Use the keyboard joystick and buttons to view and control the video. Instructions for viewing video may vary depending on the specific EDI5000 model; detailed instructions are provided in the (Design and product specifications subject to change without notice. on page 41.
NOTE: Video received from the Endura system is displayed on the matrix system monitor with a border on the display, as follows:
•Live video from an Endura system camera is displayed with a green border.
•Recorded video is displayed with a yellow border. Recorded video can be either of the following:
–Recorded video from an Endura system camera.
–Video from a matrix system camera that was recorded in the Endura system.
Recorded video starts at the point designated by the Initial Jump Back Seconds setting (as described in Change Configuration Settings on page 23). For example, if the Initial Jump Back Seconds value is set at 60 seconds, recorded video starts at 60 seconds back from the present.
HOW TO OPERATE THE EDI5000-AD2088
When an operator is viewing live video from the matrix system, the keyboard commands and options are controlled by the matrix system and they function as described in the matrix system documentation.
When an operator is viewing either live video from an Endura system camera or recorded video, the keyboard commands and options are controlled by the EDI5000 data interface and they function as described in this section.
34 |