Technicolor - Thomson LDK 20(S) Hardware Setup and Customization, Location of adjustments

Hardware Setup and Customization

The camera is delivered in a ready-to-use state, however, there are occasions when it might be necessary to re-adjust some functions after, for example, fitting a new lens.

A large number of functions can be set-up using the control facilities of the menu system. In addition to this software set-up there are some functions which can be selected or adjusted internally in the camera.

Refer to the next chapters for instructions.

Location of adjustments

Turn the two screws on the left side panel 90° counterclockwise and swing down the cover. Turn the two screws on the right side panel 90° counterclockwise and swing down the cover.

Unless mentioned otherwise the adjustments for hardware setup and customization are located at the side of the following modules:

1Front Module

2Video Processor 1

3Digital Video Processing

4Subboard DSP

5Sync. Shading

6Data Processor

7Power

8Video Miscellaneous

9Encoder

10Video Mux Ext-TP Rec

11Audio/Intercom TX-Rec

12RTS Power Miscellaneous

				6
2	3	4	5	7
1
				12
				8
				9
				10
				11

Installation Technical Manual LDK 20(S) - Studio Camera 2-3