Sync/Shading Board
24.On Video Processor 1 Board adjust the vertical sawtooth potentiometer for no sawtooth information. (Select the viewfinder R, G and B output signals in the VF/Lens - VF Inst menu.)
Measure at:
VF out R
VF out G
VF out B
Adjust with:
ZR214
ZR414
ZR614
Required result:
Video signal as flat
as possible in
vertical direction.
Video Processor 1 Board
Black Offset
25.In the Install/Gain menu set the gain for + to 12dB and for Max gain (the standard values are 6dB and 12dB).
26.While switching between 0dB gain and Max gain, adjust black level during the active line to the same as the clamp level.
Measure at:
Adjust with:
ZR208 (R)
ZR408 (G)
ZR608 (B)
Required result:
0mV (R)
0mV (G)
0mV (B)
Correct: |
|
10mV | 10µS |
100 |
|
90 |
|
10 |
|
0% |
|
Incorrect: |
|
10mV | 10µS |
100 |
|
90 |
|
10 |
|
0% |
|
Note: When the standard file is recalled the black levels are set as follows: Master=50, R=50, G=50, B=50.
Sync/Shading Board
27.In the Install/Gain menu reset the gain for + to 6dB and for ++ to 12dB.
28.Switch to Aspect Ratio 16:9 and check black shading.
29.Remove sync/shading board and Video Processor 1 board from service extender and return it to its position in the camera.
White shading exposure
30.Mount lens on camera. Switch on power.
Recall Factory Standard File on MCP or OCP or Camera. On MCP set:
OPERATE MENU |
|
|
Knee | : | Off |
Gamma | : | Lin. |
Auto Iris | : | Off |
Exposure | : | 1/1000 |
SETUP 5 MENU |
|
|
Matrix | : | 1:1 |
MAINT 1 MENU |
|
|
Wh. shading : | On | |
31.Point camera at a white uniformly illuminated test chart (preferable a spherical illuminator). Set diaphragm to F5.6 and zoom for no vignetting. Adjust illumination for an 80% video level.
32.Select the red viewfinder signal.
33.Observe the CVBS output on the waveform monitor and adjust the frame flicker potentiometer for minimum flicker between odd and even fields.
Measure at:
CVBS out
Adjust with:
R300
Required result:
Minimum variation
between fields
Adjustments | Technical Manual LDK 20(S) - Studio Camera |