Video Processor 1 Board
Setting-up the Camera
Note:
Video Processor 1 must be adjusted in combination with the Sync./Shading board.
1.For local powering of the camera in the
2.Recall Factory Standard File on MCP or OCP.
On MCP set: |
|
|
OPERATE MENU |
|
|
Knee | : | Off |
Contour | : | Off |
Gamma | : | Lin. |
Blk. Str. | : | Off |
Auto Iris | : | Off |
SETUP 1 MENU |
|
|
Studio mode: | Off | |
Flare | : | Off |
White clip | : | Off |
SETUP 2 MENU |
|
|
Soft cont. | : | Off |
SETUP 3 MENU |
|
|
Skin cont. | : | Off |
SETUP 4 MENU |
|
|
Notch | : | Off |
Chroma | : | Off |
Asp. Ratio | : | 4:3 |
SETUP 5 MENU |
|
|
Matrix sel. | : | 1:1 |
MAINT. 1 MENU |
|
|
Wh. shading : | Off | |
Oscilloscope: 10mV/div. probe 10:1
3.Put Video Processor 1 on a service extender.
4.Remove jumpers 7, 9, 11, 13, 17 and 19 from connector B of the service extender to interrupt the input from the front and jumpers 6, 12 and 15 to interrupt the black shading correction.
5.Short circuit the input to video processor 1 by connecting the following jumpers on connector B of the service extender:
B7 to B9
B11 to B13
B17 to B19
Adjustments | Technical Manual LDK 20(S) - Studio Camera |