Power Supply
5
Eng Front
Off
Prod Rear
Ext Loc
Mix
Call
CVBS (Option)
Mic
VF Ext
Front Rear 48V
Scrip
Light
Breaker | Dc in |
Power on 
1 | 2 |
|
Eng Progr Prod
4
3
1 Power switch | 4 DC input socket |
The power switch has two positions:
On | : | Power to camera is switched on. |
Off | : | Power to camera is switched off. |
When you switch off the power, the access rights that were obtained by the use of the PIN code are disabled and the camera starts at the assigned user level when switched on again.
2Power on indicator
The power on indicator lights when power is supplied to the camera and the camera power switch is on.
3Circuit breaker button (BREAKER)
If excessive current flows in the camera the circuit breaker trips and shuts off power to all the units. If this happens check the units for faults and if necessary take corrective action before pressing the circuit breaker button to reset the power.
This socket accepts a DC supply voltage of12V Nominal (11V to 17V) for powering the camera in
Caution
The input voltage must not exceed 17 Vdc.
5Triax cable socket
The power supply for the camera is normally supplied from the Base Station via the the triax cable. The triax cable is connected to this socket.
The triax cable also carries all the video, audio/ intercom and control signals between the camera and the Base Station.
Operator's Manual LDK 5400 - Triax Adapter for LDK 100 Series | Location of Controls and Functions |