JAI Appendix, CV-A11 emulating CV-M10 interfacing, WEN out on pin 6 on 6 pin connector

Page 23

CV-A11

10. Appendix

10.1. CV-A11 emulating CV-M10 interfacing

The CV-A11 has a slightly different pin configuration on the 12-pin Hirose connector, compared to the M-series. This new configuration is compliant to the EIA-J standard. This means, however, that the CV-A11 is not completely backward compatible with the CV-M10, CV-M40, etc in all cases (depending on the cable configuration). The table below shows how to change the pin configuration, by changing internal solder jumpers.

Please note: Only a qualified electronics technician or engineer should make these changes.

Hirose pin #

Function

JP2

JP3

JP5

JP1

JP4

Remarks

9

PCLK output enabled

Short

 

 

 

 

Note 2

9

No connection

Open

 

 

 

 

 

10

WEN output

 

Open

Short

 

 

 

10

Connected to ground

 

Short

Open

 

 

 

11

Ext Trigger input

 

 

 

Open

Short

 

11

+12V DC in

 

 

 

Short

Open

 

Note 1: Configuration shown in Bold+Italic is factory default setting

Note 2: The RS-232C command “CW” must be set to CLK

Fig. 28. PK8304 Rear Board of CV-A11

10.2. WEN out on pin 6 on 6 pin connector

Instead of EEN output on pin #6 on the 6 pin Hirose connector, WEN can be output by jumper settings. The 2 jumpers are found on the main board PK8298B, if the bottom plate is removed.

Signal on pin #6

JP1

JP2

Remark

EEN out

Open

Short

default

WEN out

Short

Open

 

Bold+Italic is factory default setting

JP1 JP2

Fig. 29. PK8298A main board.

- 22 -

Image 23
Contents CV-A11 CV-A11 Table of ContentsStandard Composition Main FeaturesGeneral Camera Housing and Dimensions Pin Assignment Pin Multi-connector DC-IN/VIDEO OUT, EXT.HD/VDPin Multi-connector Trigger and RS232C HD and VD input Input and Output CircuitsVideo output Trigger inputBasic functions Functions and OperationsContinuous Operation Non triggered Input-output of HD/VD SignalsEdge Pre-select Mode.TR=1 External Trigger ModesImportant notes on using this mode Edge Pre-select ModePulse width control Pulse Width Control ModeFrame delay read out Frame-delay read out ModeLong time exposure Long Time Exposure ModeStart/stop mode Start/Stop ModeSmearless mode Smearless ModeReadout format Frame rate Effective lines Partial scan readout modeOther Functions RS-232C control Configuring the CameraUseful commands CV-A11 RS-232C command listCamera Control Tool for CV-A11 1. HD/VD input-output selection Internal Switch and Jumper SettingsSelecting termination of HD/VD input signals Spectral Sensitivity SpecificationsCV-A11 emulating CV-M10 interfacing WEN out on pin 6 on 6 pin connectorAppendix Typical CCD Characteristics PrecautionsCamera type CV-A11 Revision Revision a Serial No …………… Users Record