JAI CV-M50 operation manual Location of SW2 and Jumpers, Board PK8054 Side B Board PK8057 Side a

Page 18

CV-M50

7.4. Location of SW2 and Jumpers

Jumpers are shorted with a 0 Ohm resistor or by a soldering between the 2 points. To remove the solder tin from a jumper position, use a special tin remover such as de-soldering wick.

7.4.1. Board PK8054 Side B

7.4.2. Board PK8057 Side A

JP10JP2JP1SW2

JP6JP7

JP9

JP4

JP3

JP5JP8

- 17 -

Image 18

Contents CV-M50 Declaration of Conformity Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Multi-connector DC-IN/SYNC Pin Multi-connector TriggerPin Assignment External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsCV-M50 EIA Non-interlaced / Field accumulation mode Edge pre-select mode for non-interlace onlyCV-M50 Ccir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M50 Long Time Exposure Mode EIA CcirCV-M50 Mode Setting Table for SW 1 SettingTable for Shutter Time SW2 on PK8057 Board Jumper Settings Pixel Clock OutputLocation of SW2 and Jumpers Board PK8054 Side B Board PK8057 Side aAdjustment of Video Signal Output Level 126.02 External AppearanceSpecifications Spectral SensitivityPrecautions Typical CCD CharacteristicsAppendix Camera type CV-M50 Scanning system Users Mode Settings Users ModificationsUser’s Record Revision Revision F Serial No2700-11083E F3