JAI CV-M50 operation manual Locations and Functions

Page 5

CV-M50

4. Locations and Functions

11/2" interline transfer CCD sensor.

2Lens mount of C-mount type. *1)

3BNC connector for video output.

4Switch block SW1 for shutter speed and function modes setting.

56-pin multi connector for WEN and EEN output external trigger input.

612-pin multi connector for +12V DC power, video output and HD/VD input/output.

7GAIN potentiometer for manual gain adjustment.

8Screw holes for Tripod mount plate.

9Tripod mount plate to place the camera on tripod.

Note: *1) Rear protrusion on C-mount lens must be less than 10.0 mm (0.4 inches approx.). When IR-cut filter is used, it must be less than 7.0 mm (0.28 inches approx.).

The IR cut filter is placed in the C-mount thread.

The C-mount 25 mm IR cut filter must be ordered separately.

- 4 -

Image 5

Contents CV-M50 Declaration of Conformity Table of Contents General Standard Composition Main FeaturesLocations and Functions Pin Assignment Pin Multi-connector DC-IN/SYNCPin Multi-connector Trigger Normal Shutter Mode Input/Output of HD/VD SignalExternal Trigger Mode Functions and OperationsEdge pre-select mode for non-interlace only CV-M50 EIA Non-interlaced / Field accumulation modePulse Width Control Mode CV-M50 Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M50 EIA Ccir Long Time Exposure ModeCV-M50 Table for Shutter Time Mode SettingTable for SW 1 Setting SW2 on PK8057 Board Pixel Clock Output Jumper SettingsBoard PK8054 Side B Board PK8057 Side a Location of SW2 and JumpersAdjustment of Video Signal Output Level External Appearance 126.02Spectral Sensitivity SpecificationsAppendix PrecautionsTypical CCD Characteristics User’s Record Users Mode Settings Users ModificationsCamera type CV-M50 Scanning system Revision Revision F Serial No2700-11083E F3