JAI CV-M50IR operation manual

Page 14

CV-M50IR

Cautions in the Long Time Exposure Mode.

1.Theoretical exposure time is as follows. EIA: 1/30 sec. to . CCIR: 1/25 sec. to .

2.It is recommended not to use exposure >2 sec. since visible dark-current noise may occur.

3.Ext. HD signal (4.0 Vp-p ± 2.0V at 75 Ohm terminated) has to be input continuously The falling edge of Int. HD signal and Ext. VD signal are phase-synchronized.

4.Timing of ext. VD signal in each accumulation mode has to be set, as described before.

a)2:1 Interlaced mode (Field accumulation mode)

b) 2:1 Interlaced mode (Frame accumulation mode)

c) Non interlaced mode (Field accumulation mode)

- 13 -

Image 14
Contents CV-M50IR Declaration of Conformity Table of Contents Standard Composition Main Features GeneralLocations and Functions Pin Assignment Pin Multi-connector DC-IN/SYNCPin Multi-connector Trigger External Trigger Mode Input/Output of HD/VD SignalNormal Shutter Mode Functions and OperationsCV-M50 EIA Non-interlaced / Field accumulation mode Edge pre-select mode for non-interlace onlyCV-M50 Ccir Non-interlaced / Field accumulation mode Pulse Width Control ModePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M50IR Long Time Exposure Mode EIA CcirCV-M50IR Table for Shutter Time Mode SettingTable for SW 1 Setting SW2 on PK8057 Board Jumper Settings Pixel Clock OutputLocation of SW2 and Jumpers Board PK8054 Side B Board PK8057 Side aAdjustment of Video Signal Output Level 126.02 External AppearanceSpecifications Spectral SensitivityAppendix PrecautionsTypical CCD Characteristics User’s Record Users Mode Settings Users ModificationsDisclaimer Camera type CV-M50 Scanning system2700-11083E F3