JAI CV-M50IR operation manual Adjustment of Video Signal Output Level

Page 19

CV-M50IR

8. Adjustment of Video Signal Output Level

When an alignment of a video output signal is required, remove the camera housing and adjust potentiometers VR3, VR4 and VR5 on the PK8056 board while measuring their levels at the video output connector.

This adjustment should only be done in a setup with a standard TV test chart and controlled illumination.

VR3: To adjust the gain level of AGC. (Factory setting: 700 mVp-p ± 30 mV)

VR4: To adjust the white level. (Factory setting: 800 mVp-p ± 20 mV)

VR5: To adjust the black level. (Factory setting: 20 mVp-p ± 5 mV)

CAUTION.

Do not touch these potentiometers unless you are familiar with camera adjustments.

Location of VR3 to VR5 on PK8056 board is as follow.

VR4

VR3

VR5

- 18 -

Image 19

Contents CV-M50IR Declaration of Conformity Table of Contents General Standard Composition Main FeaturesLocations and Functions Pin Multi-connector Trigger Pin Multi-connector DC-IN/SYNCPin Assignment Functions and Operations Input/Output of HD/VD SignalNormal Shutter Mode External Trigger ModeEdge pre-select mode for non-interlace only CV-M50 EIA Non-interlaced / Field accumulation modePulse Width Control Mode CV-M50 Ccir Non-interlaced / Field accumulation modePulse width control mode for non-interlace only Start/Stop Trigger Mode CV-M50IR EIA Ccir Long Time Exposure ModeCV-M50IR Table for SW 1 Setting Mode SettingTable for Shutter Time SW2 on PK8057 Board Pixel Clock Output Jumper SettingsBoard PK8054 Side B Board PK8057 Side a Location of SW2 and JumpersAdjustment of Video Signal Output Level External Appearance 126.02Spectral Sensitivity SpecificationsTypical CCD Characteristics PrecautionsAppendix Camera type CV-M50 Scanning system Users Mode Settings Users ModificationsDisclaimer User’s Record2700-11083E F3