Hitachi BE-IR31 manual HD and VD output BE-IR30 only

Page 21

11. Function setting and changes

11-7 HD and VD output (BE-IR30 only)

The BE-IR30 can be provided with horizontal and vertical drive outputs by changing chip parts. Change the following chip parts to provide HD and VD outputs.

	R233	R239	R240	R241		R242	R248	R249	R250
Factory setting	0 Ω	Absent	0 Ω	Absent		0 Ω	Absent	0 Ω	Absent
HD & VD output	Delete	0 Ω	Delete	0 Ω		Delete	0 Ω	Delete	0 Ω
0 Ω ：	Part code		RME1784
	Type		ERJ3GEYJ0R00V

Connector pin assignments after change

Pin No.	Signal
１	Video out
２	Video GND
３	GND
４	+9V
５	HD out
６	VD out
７	HD/VD GND

Note: The accessory cable cannot be used for signal outputs.

Location of chip resistors(Main board side B)

BE-IR30 / 31

20

Image 21

Contents Infrared B/W Camera Module Operation Guide Table of Contents Introduction SpecificationsGeneral Composition．Specifications Auto electronic shutter BE-IR30 BE-IR30 External view External view Optical dimensions Two 2.5 mm Dia InstallationBLK GRN YEL RED Typical connectionTypical connection External sync BE-IR31 AGC on / off Function setting and changesGamma response Function setting and changesAuto electronic shutter on / off Fixed Changes to fixed shutter modeBE-IR30 external sync BE-IR31 internal sync HD and VD output BE-IR30 only Options Options BE-IR30C/31C and CS mount adapter option combined dimensions Spectral sensitivity typical example U t i o n