Hitachi BE-IR30, BE-IR31 manual Installation, Two 2.5 mm Dia

Page 11

8.Installation

When installing the camera in a housing or unit of equipment, secure with two M2 screws inserted into the 2.5 mm diameters holes of the SENS board base plate.

Two 2.5 mm Dia.

SENS board

1.Use the SENS board holds to install the camera. Avoid using only the Main board,

Notes : due to risk of damage to the board connector.

2.Avoid unnecessary stress on the printed board when engaging and disengaging the connectors.

3.The screws securing the base plate and SENS board protrude a maximum of 2 mm from the base plate. Observe these screws do not contact the housing or installed equipment.

BE-IR30 / 31

10

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Infrared B/W Camera Module Operation Guide Table of Contents Composition SpecificationsIntroduction General．Specifications Auto electronic shutter BE-IR30 BE-IR30 External view External view Optical dimensions Two 2.5 mm Dia InstallationBLK GRN YEL RED Typical connectionTypical connection External sync BE-IR31 AGC on / off Function setting and changesGamma response Function setting and changesAuto electronic shutter on / off Fixed Changes to fixed shutter modeBE-IR30 external sync BE-IR31 internal sync HD and VD output BE-IR30 only Options Options BE-IR30C/31C and CS mount adapter option combined dimensions Spectral sensitivity typical example U t i o n
Top Page Image Contents