First Alert K5309-5V2 manual $ERXW6FKHGXOLQJ, UHDWLQJ6FKHGXOHV

6FKHGXOLQJ￿

$ERXW￿6FKHGXOLQJ￿

The system provides end-user schedules (programmable by master/installer only), which can control various types of events.

• Each schedule causes a defined event to start and stop (when appropriate) at a specified time.

• Schedules can be set to automatically repeat at various intervals.

• Schedules can be set for random starting, if desired.

• FA168CPS provides up to 16 user schedules; FA148CP provides up to 4 user schedules.

&UHDWLQJ￿6FKHGXOHV￿

1.	+ [#] + [6] [4]	Alpha￿6)%(=-Displays:7%61)(83%61
(Master Code)
2. Enter a 2-digit schedule number from:
			)28)67',)(23￿
01-16 (FA168CPS) or 01-04 (FA148CP).
Press [∗] to continue.			￿￿=59-):)28 ￿￿
			)28)6
3. Enter the desired 2-digit event number from the
following list.
00	= clear the scheduled event
01	= turn a programmed output on or off
	(see Using Device Commands section for a list of output device numbers used
	in your system)
02	= set a user access schedule for one or more users
	(see Security Codes section for an explanation of access groups)
03	= send a “latch-key” report to a pager if the system is not disarmed by a specified
	time; message sent is “777-7777.”
04	= automatically arm the system in STAY mode at a specified time
05	= automatically arm the system in AWAY mode at a specified time
06	= automatically disarm the system at a specified time
07	= Display the word “REMINDER” at a specified time
	(if selected, the keypad will beep every 30 seconds beginning when the word
			():-')291&)6

“REMINDER” is scheduled to display. To stop the beeps and cancel the display once it starts, simply press any key.

Press [∗] to continue.

4. For event number “01,” enter the output number
associated with this schedule.
Otherwise, this prompt is skipped.	<<
Press [∗] to continue to the “Start” prompt below.

– 35 –