FujiFilm A330 owner manual Erase ALL

Troubleshooting				Possible causes			Solutions
Frame erase does not				Some frames may be protected.		Unprotect frames using the camera on
erase the frame.						which the protection was first applied.
The	ERASE		ALL
function does			not
erase all the frames.
Nothing happens when				i Camera malfunction.		i Briefly	remove the batteries or
I press the “Playback”						disconnect the AC power adapter.
button on the camera.						Then reload the batteries or reconnect
						the AC power adapter and try again.
				i The batteries run out.		i Load new or fully charged batteries.
Screens		are	not	i A language other than English is		1Press the “MENU/OK” button to display
displayed in English.				selected in the “	” setting in	the menu on the LCD monitor.
				SET-UP (➡P.49).		2Press “d” or “c” to select “F” and
						press “a” or “b” to select “SET-UP”
						(SET-UP screen appears on the LCD
						monitor).
						3Press “d” or “c” to move to option 3
						and then use “a” or “b” to select
						“	”.
						4Press “d” or “c” several times to select
						“ENGLISH”.
						5Press the “MENU/OK” button.
There is no image on				i The included video	cable was	i After the movie playback mode is
the TV.				connected during movie playback.		stopped, connect the camera and TV
						correctly.
				i The camera is not connected to the TV		i Connect the camera and TV correctly.
				correctly.
				i “TV” is selected as the TV input.		i Set the TV input to “VIDEO”.
				i The video output setting is incorrect.		i Change the setting to “NTSC” or “PAL”
						(➡P.49).
When the camera is				i The USB cable (included) is not		i Set up the camera and the USB cable
connected		to	a	correctly connected to the PC or		(included) correctly.
personal		computer		camera.
(PC), the photographed				i The PC is not turned on.		i Turn the PC on.
image appears on the
camera’s LCD monitor.
The camera no longer				The camera has suffered an unforeseen		Briefly remove the batteries or
works correctly.				problem.		disconnect the AC power adapter. Then
						reload the batteries or reconnect the AC
						power adapter and try again.
Can’t	print		with	“¢” is not selected in USB mode in		Select “¢” in USB mode in the SET-
PictBridge.				the SET-UP menu.		UP menu.
The	camera		was			Perform steps 1 to 3 to remove the
connected to PC when						camera from PC.
the USB mode was						h Windows
set to “¢”.						1 The “New Hardware Found” wizard
						(or “Scanner and Camera” wizard)
						appears. If the wizard does not
						appear, proceed to step 3.
						2 Click the [Cancel] button.
						3 Disconnect the camera from the PC.
						h Macintosh
						1 The window for locating the driver
						appears. If the window does not
						appear, proceed to step 3.
						2 Click the [Cancel] button.
						3 Disconnect the camera from the
						Macintosh.		81