Windows
D1-Series Cameras
Windows XP Home Edition/Professional
Before You Begin
Confirm that your
Select Control Panel from the Start menu. In the Control Panel window, click the Perfor- mance and Maintenance icon to open the Performance and Maintenance window. Click the System icon in the Performance and Maintenance window to open the System Properties window. Select the Hardware tab and click the Device Manager button to open Device Manager window shown at right.
The bus controller for your IEEE 1394 board or card should be listed un- der “1394 Bus host con- trollers.”
If “IEEE 1394 Bus host controllers” is not listed in the Device Manager, or if your IEEE 1394 interface board or card is listed as an unknown or miscellaneous device or is preceded by a red or yellow warning icon, follow the instructions in the manual provided with the board to ensure that the drivers are properly installed.
After installing Nikon Capture 3 and restarting the computer, connect your camera to the computer using an IEEE 1394 cable and turn the camera on. The camera will be registered automatically.
Follow the instructions below to check that the camera has been correctly registered with the system.
Step 1
Once registration is complete, check that the D1X (or D1 or D1H) has been correctly regis- tered with the system. Open the Device Man- ager as instructed in Steps
Logging On
You will need to log on as the “Computer Administrator” to register your camera.
Before Connecting the Camera
Be sure to install Nikon Capture 3 before connecting your camera to the computer.
68