Minolta Dynax 7, Minolta, Maxxum manual Exposure Bracketing, 0.5, 0.7, 1.0 EV

EXPOSURE BRACKETING

Exposure bracketing automatically exposes a series of frames with exposures above and below the metered exposure value. Bracket your exposures when shooting slides and other films with a low tol- erance for exposure error. A larger bracketing increment is recom- mended when shooting negative film.

• This camera can expose a 3, 5, or 7 frame brackets in increments of

3.Turn the front control dial to set the bracketing increment

(0.3, 0.5, 0.7, 1.0 EV).

0.3, 0.5, 0.7, or 1.0 EV.

1.Turn the drive-mode lever to the desired bracketing mode.

S - Single Frame Advance C - Continuous Advance

4. Turn the rear control dial to set the size of the bracket (3, 5 or 7 frames).

DRIVE

2. Open the control-panel door, then press the adjust button.

• The current bracketing increment and size of the bracket is shown in the display.

Exposure-bracket- ing indicator

Front-control-dial indicator

Meter index

Rear-control-dial indicator

•Press the shutter-release button partway down

to enter the setting. remains for single

frame advance, remains for continuous frame advance mode.

5.Compose (and meter) your subject, then press the shut- ter-release button all the way down to start the bracket- ing.

•InS - Single-frame advance, press the shutter-release button for each exposure.

•InC - Continuous advance, hold the shutter-release button until the series is finished.

92 93