Minolta Dynax 7 Setting the ISO Manually, Turn either control dial to set the desired ISO value

SETTING THE ISO MANUALLY

Set the ISO manually to override the DX-coded ISO or when using non- DX coded film.

•Film must be loaded before the ISO can be changed.

•Non-DX coded film is initially set to the previous roll’s ISO.

1. Open the control-panel door and press the ISO button.

• The current ISO is shown in the display.

2. Turn either control dial to set the desired ISO value.

• The ISO can be changed manually from 6 to 6400 in 1/3 EV increments.

3.Press the shutter-release but- ton partway down to enter the new ISO.

Custom 4-2 DX Memory ON (p. 164).

Applies ISO changes to future rolls with the same DX-coded ISO.

DRIVE

Continuous drive, exposure bracketing, multiple exposures, and other options can be selected using the drive-mode lever.

The standard drive-mode setting for this camera is single-frame (drive-mode lever set to ).

The selectable modes are represented	DRIVE
by;

(Single-frame advance)

(Continuous advance)

Bracketing

S (Single frame advance)

C (Continuous advance)

Self-timer

Multiple Exposure

•The drive-mode lever can not be changed while pressing the exposure-mode dial lock-release button.

86 87