DeWalt DXPW3025 INSTALLATION Pressure Washer Assembly Fig, Operation, Pressure Adjustments

INSTALLATION

Pressure Washer Assembly (Fig. 1)

NOTE: The high-pressure pump was filled with oil at the factory. Always check oil level before using (refer to Maintenance for more information).

1.Place handle (O) onto frame (F) and secure with saddle bolts and knobs (R).

Caution: Risk of personal injury. Avoid placing hands between handle and frame when assembling to prevent pinching.

2.Attach high-pressure hose (P) to spray gun. Make sure it is secure.

3.Connect wand (E) to spray gun. Make sure connection is secure.

o

f

r

Warning: Risk of bursting. Use a tire pressure gauge to check the tires pressure before each use and while inflating tires; see the tire sidewall for the correct tire pressure.

NOTE: Air tanks, compressors and similar equipment used to inflate tires can fill small tires similar to these very rapidly. Adjust pressure regulator on air supply to no more than the rating of the tire pressure. Add air in small increments and frequently use the tire gauge to prevent over inflation.

OPERATION

English

p

e

Pressure Adjustments

The pressure setting is preset at the factory to achieve opti­mum­ pres­ sure and cleaning. To lower the pressure,­ follow these instructions.

1.	Back away from the surface­ to be cleaned. The further away you
	are, the less the pressure will be on the surface to be cleaned.
2.	Change to the 40˚ nozzle (white). This nozzle delivers a less

4.Place the nozzle holder (B) onto the panel assembly (A) and push each nozzle holder into place.

5. Remove	the	five
colored	quick-		B
connect nozzles from
the plastic bag		and	A
insert	them	into
correct grommet		on

the nozzle holder. Nozzles are color coded to match colored nozzles on panel assembly.

powerful stream of water and a wider spray pattern. Refer to

Spray Wand Nozzles.

NOTICE: DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump.

3.Reduce the speed of the gasoline engine (RPM). Slow the engine down and the water pressure will go down with it.

Spray Wand Nozzles (Fig. 1)

The nozzles for the spray wand are stored in the nozzle holder (B) on the panel assembly (A). Colors on the panel identify nozzle location and spray pattern. Refer to the following chart to choose the correct nozzle for the job to be performed.

11