English
3. | Disconnect the spray wand from the gun. | Y | Pump | ||
4. | Remove the |
| The manufacturer recommends using a pump protector/ | ||
| spray wand. Remove any obstructions with |
| winterizer when storing the unit for more than 30 days and/or | ||
| the nozzle cleaning tool (Y) provided and |
| when freezing temperatures are expected. If a pump protector/ | ||
| back flush with clean water. |
| winterizer is not available, RV antifreeze can be used as outlined in the | ||
5. | Direct water supply into spray wand to |
| following steps. | ||
| back flush loosened particles for 30 |
| NOTE: Using a pump protector/ winterizer or RV antifreeze helps | ||
| seconds. |
| to provide proper lubrication to the internal seals of the pump | ||
6. | Reassemble the nozzle to the wand. |
| regardless of temperature or environment. | ||
7. | Reconnect spray wand to gun then turn on water supply. | 1. | Obtain a funnel, 6 oz. (170 mL) | ||
8. | Start pressure washer and place spray wand into high pressure |
| of RV antifreeze and | ||
| setting to test. |
|
| 91cm) of garden hose with a male | |
To Clean the Water Inlet Filter |
|
| hose connector attached to one | ||
|
| end. | |||
This filter screen (U) should be checked periodically and cleaned if | NOTICE: Risk of property damage. | ||||
necessary. |
| Use only RV antifreeze. Any other anti | |||
1. | Remove the filter screen (U) by grasping the |
| freeze is corrosive and can damage | ||
| end and removing it from water inlet of pump. |
| pump. | ||
2. | Clean filter by flushing it with water on both |
| 2. | Disconnect spark plug wire. | |
| sides. |
| 3. | Connect length of garden hose | |
3. | Reinsert filter into water inlet of pump. Cone |
|
| to water inlet of pump. | |
| side faces out. | U | 4. | Add RV antifreeze to hose as shown. | |
NOTE: Do not operate pressure washer without | 5. | Pull engine starter rope slowly several times until antifreeze | |||
| |||||
filter properly installed. |
| ||||
|
| comes out of | |||
sTORAGE |
| 6. | Remove garden hose from water inlet of pump. | ||
| 7. | Reconnect spark plug wire. | |||
Engine |
| ||||
|
|
|
Consult the engine instruction manual for the manufacturer's recommendations for storage.
16