Nikon SB-102 instruction manual Basic OPERATIONS-confinued

Page 10

BASIC OPERATIONS-confinued____

11 Insert the joint plate

• into the joint collar @ .

While holding the base of the joint knob against the joint, slide the joint plate into the joint collar until it is fully seated.

o When inserting the joint plate into the joint collar, be sure the flat edges of the joint plate remain parallel to the flat edges of the joint.

12 Lock the joint.

Align the flash head position- ing index @ with the "normal " posi- tion mark on the flash head posi- tioning scale, then turn the joint knob clockwise until the joint is locked in position.

oSee page 18 for information about removing the joint.

13. Loosen the joint lever @.

Turn the jOint lever counterclock- wise as far as it will go to loosen it.

14 Insert the arm @ into

• the joint.

Insert the arm positioning screw @ into the slot in the joint. The arm can be inserted from either side of the joint. The normal position is shown in the photo.

15 Position the arm .

Align the arm positioning screw with the arm positioning index @ on the joint by turning the arm 90°.

16 Lock the arm .

After aligning the arm posi- tioning screw with the arm position- ing index, turn the joint lever clock- wise as far as it will go to lock the arm into position .

oNormally, the joint is locked at the top of the arm.

o Before diving, be sure the jOint knob and joint lever are locked tightly.

10

Image 10
Contents Nikon Nomenclature Exposure calculation dialContents Foreword PreparationPreparation Preparation O-rings and their sealing methodTips on Speedlight Care Install the batteries Basic OPERATI,O..N~S.... =======~===~=----==-=Loosen the joint Knob Replace the battery chamber capLock the buckle lockl Release latches Lock the bucklesBasic OPERATIONS-confinued Attach the bracket To the arm Loosen the arm Knob @Attach the cord Fastening hanger to the bracket Remove Camerasflash sync socket coverRemove the synchro Socket cover Set the ASA/ISO film speed Set the shutter Speed on the cameraNon-TTL. Automatic Operation Turn on the flash unit Wait for the ready Light to lightTake the picture Turn off the flash unitControls in DETAIL~~-=~ksens~orun~itSU----101 BracketControls in Detail Close-Up Shooting in the Non-TTL Automatic ModeJoint @ Synchro Socket Sensor SocketSensor Unit SU-101 Optional Synchronization SpeedShooting Mode Selector Exposure Calculation Dial TTL Automatic Flash ControlTTL Auto Shooting Range Non-TTL Automatic Flash Control ExampleManual Flash Control Guide Numbers in the Manual Mode Ready-Light Test Firing Other Warning FunctionsWide-Flash Adapter SW-102 Cord Fastening Hanger @Attaching the SW-102 Target-Light FunctionMultiple Flash Photography Replacing the Target-lightDaylight Fill-In Flash Photography Tips on Speedlight Photography Optimum Battery Performance New batteries PolarityAccessories Accessories MarkSpecifications ModesNlro