Nikon SB-102 instruction manual Remove the synchro Socket cover

Page 12

BASIC OPERATIONS-confinued____

22 Connect the sync

• cord @ to the camera .

Remove the dust-proof plastic cap from the sync cord's camera plug (silver) . Insert the camera plug in the camera's flash socket after aligning the white index on the flash sync socket with the red index on the camera plug . When the camera plug is inserted, turn its locking ring clockwise as far as it will go to secure the plug .

24 Connect the sync

• cord to the 58-102.

Remove the dust-proof plastic cap from the sync cord's speedlight plug (black). Insert the speedlight plug into the synchro socket after aligning the synchro socket index CD with the red index on the speed- light plug. When the speedlight plug is inserted, turn its locking ring clockwise as far as it will go to secure the plug .

Check the a·ring : Before con- necting the camera plug to the camera, examine the plug 'sO-ring for dust and scratches and be sure it is properly seated and lubricated.

o Do not apply excessive force to the sync cord's camera plug, and avoid twisting the cord as much as possible.

Check the a·ring: Before connect- ing the speedlight plug to the speedlight, examine the plug 's O-ring for dust and scratches and be sure it is properly seated and lubricated.

•To keep the sync cord out of the way while shooting, attach it to the hook of the cord fastening hanger.

23 Remove the synchro

• socket cover ® .

Turn the synchro socket cover counterclockwise, then pull it up.

25 Confirm the position

• of the flash head.

Confirm that the arm positioning screw is aligned with the arm posi- tioning index, the flash head posi- tioning index is aligned with the

"normal " position mark on the flash head positioning scale, and the flash head is facing in the same direction as the camera's lens. If the arm positioning screw is not properly aligned, loosen the joint lever to reposition it. If the flash head positioning index is not pro - perly aligned loosen the jOint knob to reposition it.

oSee page 18 for information about position-

ing the flash head for close -up shooting within approximately 1m (3.3 fO.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Nikon Nomenclature Exposure calculation dialContents Foreword PreparationPreparation Preparation O-rings and their sealing methodTips on Speedlight Care Install the batteries Basic OPERATI,O..N~S.... =======~===~=----==-=Replace the battery chamber cap Lock the buckle lockl Release latchesLoosen the joint Knob Lock the bucklesBasic OPERATIONS-confinued Loosen the arm Knob @ Attach the cord Fastening hanger to the bracketAttach the bracket To the arm Remove Camerasflash sync socket coverRemove the synchro Socket cover Set the ASA/ISO film speed Set the shutter Speed on the cameraNon-TTL. Automatic Operation Turn on the flash unit Wait for the ready Light to lightTake the picture Turn off the flash unitControls in DETAIL~~-=~ksens~orun~itSU----101 BracketClose-Up Shooting in the Non-TTL Automatic Mode Controls in DetailJoint @ Synchro Socket Sensor SocketSensor Unit SU-101 Optional Synchronization SpeedShooting Mode Selector Exposure Calculation Dial TTL Automatic Flash ControlTTL Auto Shooting Range Non-TTL Automatic Flash Control ExampleManual Flash Control Guide Numbers in the Manual Mode Ready-Light Test Firing Other Warning FunctionsCord Fastening Hanger @ Attaching the SW-102Wide-Flash Adapter SW-102 Target-Light FunctionReplacing the Target-light Multiple Flash PhotographyDaylight Fill-In Flash Photography Tips on Speedlight Photography Optimum Battery Performance New batteries PolarityAccessories Accessories MarkSpecifications ModesNlro
Top Page Image Contents