Synchro Socket, Sensor Socket | Nikon SB-102 guide

Synchro Socket ®

To connect the sync cord @) to the speedlight, remove the synchro socket cover ® by turning it counterclock- wise and pulling it up. Remove the dust-proof plastic cap from the sync cord 's speedlight plug @ (black). Insert the speedlight plug into the synchro socket after aligning the synchro socket index CD with the red index on the speedlight plug . When the speedlight plug is inserted, turn its locking ring clockwise as far as it will go to secure the plug .

Never submerge the speedlight in water with the synchro socket cover removed or get the sync cord plugs wet. Always make sure either the synchro socket cover or the sync cord plugs are securely attached before entering the water.

After shooting underwater, wipe off any water droplets with a soft cloth before removing the plug to prevent water from entering the socket. Whenever the sync

Sensor Socket (])

To connect the sensor cord to the speedlight for non- TTL automatic flash control , remove the sensor socket cover @ by turning it counterclockwise and pulling it up. Remove the dust-proof plastic cap from the sensor cord 's speedlight plug (black). Insert the speedlight plug into the sensor socket after aligning the sensor socket index @ with the red index on the speedlight plug. When the speedlight plug is inserted, turn its lock- ing ring clockwise as far as it will go to secure the plug.

Never submerge the speedlight in water with the sensor socket cover removed or get the sensor cord plugs wet. Always make sure either the sensor socket cover or the sensor cord plugs are securely attached before entering the water.

After shooting underwater, wipe off any water droplets with a soft cloth before removing the plug to prevent water from entering the socket. Whenever the sensor

cord is not being used or the speedlight is being washed with the sync cord removed from the synchro socket, attach the synchro socket cover to protect the socket. To attach the socket cover press it against the socket to seat the O-ring , then turn the locking ring clockwise as far as it will go.

•To simplify identification, both the tip of the sync cord's speedlight plug and the inside of the synchro socket are color· coded yellow.

cord is not being used or the speedlight is being washed with the sensor cord removed from the sensor socket, attach the sensor socket cover to protect the socket. To attach the socket cover, press it against the socket to seat the O-ring, then turn the locking ring clockwise as far as it will go.

•To simplifty identification, both the tip of the sensor cord 's speedlight plug and the inside of the sensor socket are color-coded black.