Adjusting Speaker Levels with the Test Tone

Adjusting Speaker Levels with the Test Tone

English

It’s important that all speakers can be heard equally at the listening position. The TSS-15 has a built-in test tone for adjusting the level of each speaker.

Notes:

•The test tone cannot be used while a pair of headphones is connected.

•The Night listening mode cannot be used while the test tone is being output.

•The test tone can be used with the Virtual Surround func- tion (see page 16).

3 Press the [TEST] button.

The test tone is output by each speaker for 2.5 seconds in the following order: front left, center, front right, sur- round right, surround left, subwoofer.

The TSS-15’s CINEMA DSP buttons indicate which speaker is currently outputting the test tone, as shown below.

MOVIE MUSIC SPORTS GAME

MODE

STANDBY/ON

STANDBY/ON [ ]

MOVIE MUSIC SPORTS GAME

VOLUME

MUTE VOLUME +/–

SP LEVEL

NIGHT

SW CENTER SURR TEST

TEST

DUAL MONO

		Front left		Front right
		speaker		speaker
	Subwoofer			Center
	Subwoofer			speaker
				speaker
MOVIE	MUSIC	SPORTS	GAME	Listening
				position
	Surround left			Surround right
		speaker		speaker

1 2 3 4

INPUT

TSS-15 WD76700

This procedure should be performed from the listening position.

1 To turn on the TSS-15, press the [STANDBY/ON] button.

The STANDBY/ON button on the TSS-15 lights up.

2 Set the volume to about 4.

MOVIE

MUSIC

SPORTS

GAME

MOVIE

MUSIC

SPORTS

GAME

Note:

If the test tone is too quiet, turn up the TSS-15 ampliﬁer’s VOLUME control. If it’s too loud, turn it down.

4 While the test tone is being output by a speaker, use the VOLUME Up [+] and Down [–] buttons to adjust its level.

While the level is being adjusted, the test tone will con- tinue to be output by the same speaker. When you stop adjusting the level, the test tone will be output by the next speaker in the order stated above.

Notes:

•The level of each speaker is shown by the volume level indicators on the TSS-15 (–6, –4, –2, 0, +2, +4, +6).

•The front left and right speaker levels cannot be set above 0.

•To reset all speakers to their default levels, while the test tone is being output, press the TSS-15 ampliﬁer’s [MODE] button for two seconds.

5 When you’ve ﬁnished adjusting the level of each speaker, press the [TEST] button again to turn off the test tone.