Diameter 40 mm 20 mm 5 mm gap minimum

2 Position the speaker on the wall where you want to hang it, and use a pencil to mark the two hole positions.

4 mm

diameter

40 mm

20 mm 5 mm gap minimum

3 Screw two #8 screws into the wall, leaving a 5 mm gap to accept the keyhole slots.

4 Thread the speaker cord around the strain- relief guide and out through the slot at the front of the speaker stand, as shown.

•Do not use nails or double-sided tape to mount the speakers.

•Use cord clips to secure the speaker cords to the wall.

■Securing the Center Speaker to Your TV

To prevent the center speaker from slipping, you can secure it to your TV by using the fastener provided. You must remove its stand ﬁrst.

Notes:

•Do not put the center speaker on top of your TV if it overhangs (i.e., the top of the TV is not deep enough).

•Do not put the center speaker on top of your TV if the top is not level.

•Do not touch the adhesive side of the fastener after peel- ing off the backing.

•Wipe the top of your TV before attaching the fastener.

1 To remove the center speaker’s stand, using a

Phillips screwdriver, remove the screw and washer at the back of the stand.

Keep the screw and washer for future use.

2 Peel the backing off one side of the fastener, and afﬁx it to the top of your TV.

3 Peel the backing off the other side of the fastener, and afﬁx the center speaker on top.

English

5 Fit the speaker stand onto the screws and
push it down so that the screw heads sit
correctly in the keyhole slots.	Bottom of speaker

Peel off the backing

40 mm

Cautions:

•Each satellite speaker weighs 0.4 kg. Heed the following cautions to ensure that the speakers do not fall and cause damage or injury.

•Once the satellite speakers have been mounted on the wall, check each speaker to ensure that there’s no possi- bility of it falling. Yamaha cannot be held responsible for any damage or injury caused by falling speakers.

•If you have hollow walls, make sure that the screws go into the studs. If there are no studs, or the walls are solid, use suitable wall anchors.

•Use 1-inch #8 screws (4 mm shank diameter) with a head diameter of 8 mm or less.

Note:

Although the speakers are magnetically shielded to prevent interference, if the TV picture is distorted, try moving the speakers away from your TV.