Ricoh FV-G030B1 manual 13/37

Page 13

3.3.2Exposure Timing with the Positive Polarity Trigger Signal

Input Trigger signal

Trigger signal

(With Photocoupler delay

Filtering *Note.1

Less than 30 CLK 5useconds

T1'

Exposure time

SUB

75 CLK

Exposure tim: T1' = Preset exposure time

SG

Note 1: The trigger signal will be removed by the filtering if the pulse width of the input trigger signal is less than 30 CLK. Please input a trigger signal with more than 31 CLK pulse width.

Note 2: The exposure will start 105 CLK after the rising edge of the trigger signal.

3.3.3Exposure Timing with the Negative Polarity Trigger Signal

Input Trigger signal

Trigger signal

(With Photocoupler delay

Filtering *Note.1

Less than 30 CLK 60 useconds

T1'

Exposure time

SUB

75 CLK

Exposure tim: T1' = Preset exposure time

SG

Note 1: The trigger signal will be removed by the filtering if the pulse width of the input trigger signal is less than 30 CLK. Please input a trigger signal with more than 31 CLK pulse width.

Note 2: The exposure will start 105 CLK after the rising edge of the trigger signal.

FV-G030B1

13/37

User’s Guide Rev. 1.01

 

Image 13
Contents FV-G030B1 User’s Guide Rev GigE Vision VGA Monochrome CCD Camera FV-G030B1Table of Contents RJ45 Connector Connector SpecificationsPower-I/O Connector DC Iris Lens ConnectorFV-G030B1 User’s Guide Rev Or equivalent connector Equivalent Circuit for the Input Pin of the I/O ConnectorTriggerIn+ IOOutVertical Timing Full Scanning Horizontal TimingFixtrig AOI Area of InterestPixel Transferring Image Pulse Width Trigger Mode Normal Mode Timing Input Trigger signal Exposure Timing with the Positive Polarity Trigger SignalTrigger signal Trigger signal With Photocoupler delayEdge Preset Trigger Mode 13/37 14/37 15/37 Reset Mode Communication Method Communication SettingsCommunication Format Name Descriptions 【Example Code】Reading the data from the command 00H Camera Command List Device Code Camera Control Command21/37 22/37 23/37 Underline settings are the factory default settings Descriptions of the Camera Control Commands Device code25/37 26/37 27/37 28/37 29/37 AGC Descriptions of the Camera Commands Device code31/37 32/37 33/37 GenICam command Device Command Function GenICam Command / Camera Command Reference Table2EH 36/37 37/37
Related manuals
Manual 38 pages 11.47 Kb