Ricoh FV-G030B1 manual Table of Contents

Table of Contents

1	Connector Specifications		3
	1.1	RJ45 Connector	3
	1.2	DC Iris Lens Connector	4
	1.3	Power-I/O Connector	4
	1.3.1 Equivalent Circuit for the Input Pin of the I/O Connector		6

2	Camera Output Timing Charts		7
	2.1	Horizontal Timing	7
	2.2	Vertical Timing	7
	2.2.1 Full Scanning		7
	2.2.2 AOI (Area of Interest)		8
	2.3	Pixel Transferring Image	9

3	Camera Operational Modes		10
	3.1	Normal Mode	10
	3.2	Pulse Width Trigger Mode	10
	3.2.1 Timing		10
	3.2.2 Exposure Timing with the Positive Polarity Trigger Signal		11
	3.2.3 Exposure Timing with the Negative Polarity Trigger Signal		11
	3.3	Edge Preset Trigger Mode	12
	3.3.1 Timing		12
	3.3.2 Exposure Timing with the Positive Polarity Trigger Signal		13
	3.3.3 Exposure Timing with the Negative Polarity Trigger Signal		13
	3.4	Edge Preset Trigger Mode (Trigger Input While the Image Is Out)	14
	3.4.1 Timing		14
	3.4.2 Exposure Timing with the Positive Polarity Trigger Signal		15
	3.4.3 Exposure Timing with the Negative Polarity Trigger Signal		15
	3.5	H Reset Mode	16

4	Communication Protocol		17
	4.1	Communication Method	17
	4.2	Communication Settings	17
	4.3	Communication Format	17
	4.4	Camera Control Command	20
	4.4.1 Camera Command List (Device Code: 000000)		20
	4.4.2 Camera Command List (Device Code: 100000)		22
	4.4.3 Descriptions of the Camera Control Commands (Device code: 000000);		24
	4.4.4 Descriptions of the Camera Commands (Device code: 100000);		30
	4.5	GenICam Command / Camera Command Reference Table	34

FV-G030B1	2/37
User’s Guide Rev. 1.01