Ricoh FV-G030B1 manual Communication Method, Communication Settings, Communication Format

Page 17

4Communication Protocol

This camera has a communication function that enables external devises, such as a PC, to control the camera’s functions.

Please use the “R-GigE-Software” communication software, or the following communication protocol to communicate to the camera:

4.1Communication Method

UART（RS232C）,binary communication

4.2Communication Settings

	Settings
Baud Rate	115,200 bps
Data Bit	8 bit
Parity	None
Stop Bit	1 bit
Flow Control	None

4.3Communication Format

The Sending data format from the PC to the camera is as follows:

SOF

Device

Read/Write

Page

Command

Data

Data

EOF

Code

Selection

Code

Length

(8bit)

(6bit)

(1bit)

(1bit)

(8bit)

(8bit)

(R: 1 byte, dummy)

(8bit)

(W: n bytes)

The Receiving Data format from the camera is as follows:

After sending the Write Command:

SOF	Data Length	Receiving Code	EOF
(8bit)	(8bit) “00H”	(1 byte)	(8bit)

After sending the Read Command:

SOF	Data Length	Data	EOF
(8bit)	(8bit)	(n bytes)	(8bit)

	FV-G030B1	17/37
	User’s Guide Rev. 1.01	17/37
	User’s Guide Rev. 1.01

Image 17

Contents FV-G030B1 User’s Guide Rev GigE Vision VGA Monochrome CCD Camera FV-G030B1Table of Contents RJ45 Connector Connector SpecificationsPower-I/O Connector DC Iris Lens ConnectorFV-G030B1 User’s Guide Rev Or equivalent connector Equivalent Circuit for the Input Pin of the I/O ConnectorTriggerIn+ IOOutVertical Timing Full Scanning Horizontal TimingFixtrig AOI Area of InterestPixel Transferring Image Timing Normal ModePulse Width Trigger Mode Input Trigger signal Exposure Timing with the Positive Polarity Trigger SignalTrigger signal Trigger signal With Photocoupler delayEdge Preset Trigger Mode 13/37 14/37 15/37 Reset Mode Communication Format Communication SettingsCommunication Method Name Descriptions 【Example Code】Reading the data from the command 00H Camera Command List Device Code Camera Control Command21/37 22/37 23/37 Underline settings are the factory default settings Descriptions of the Camera Control Commands Device code25/37 26/37 27/37 28/37 29/37 AGC Descriptions of the Camera Commands Device code31/37 32/37 33/37 GenICam command Device Command Function GenICam Command / Camera Command Reference Table2EH 36/37 37/37

Related manuals

Manual 38 pages 11.47 Kb