7Switch off with STANDBY/ON m .
The programmed recording will only function when the video recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video recorder display.
Problem solving for programmed recordings
ENGLISH
PROBLEM
The video recorder does not react
'SWITCH TO STANDBY- TIMER RECORDING' flashes on the TV screen
A cassette was automatically ejected during recording
Error message: 'NO CASSETTE' ' k ' will flash in the video recorder display
The 'PROTECTED
CASSETTE' error message appears briefly on the screen then the cassette is ejected
SOLUTION
bWhile a programmed recording is being made, you cannot operate your video recorder manually. If you want to cancel the programmed recording, press STANDBY/ON m .
bThe video recorder was switched on several minutes before the start of a programmed recording. Switch off the video recorder with STANDBY/ON m . A programmed recording (timer) will only function if the video recorder is switched off.
bThe end of the tape was reached during recording.
bNo cassette was inserted. Insert a cassette and switch off the video recorder using STANDBY/ON m .
bA cassette was inserted with the security tab removed. Undo the erase protection (chapter 'Manual Recording', section 'Preventing accidental erasing of cassettes') or insert a different cassette.
Error message: 'ALL
TIMERS OCCUPIED'
The 'DATA ERROR' message appears on the screen
bIf this error message appears after pressing TIMER k , then all TIMER blocks are already programmed. No more recordings can be programmed. If you want to clear or check a programmed recording (TIMER block), select it with P ;q or P =r .
bThe data for the recording could not be transferred. Please check date, start time and end time of the programmed recording.
Programming a recording (TIMER) | 33 |
|