AC GROUND
The LF 6600 chassis should be connected to earth ground for operator safety. The AC power cord has a grounding conductor which connects the LF 6600 chassis to safety ground through the site AC power system. If the site AC system ties its ground wire connection to earth ground, then the LF 6600 chassis will also be tied to earth ground. All site AC power connections must be maintained on the same safety ground.
A line grounding connector located on the rear panel can also be used to tie the LF 6600 chassis to earth ground. This ground connector is a
AC POWER CORD
The type of AC power cord supplied with the LF 6600 will depend upon the configuration ordered.
POWER SUPPLY OUT-OF-RANGE PROTECTION FEATURES
The LF 6600 power supply provides over and under voltage protection, over current protection, power failure detection and over temperature protection. Should an
TILT RANGE
The LF 6600 is not designed for use when tilted from the vertical position.
HEAT DISSIPATION
The drive will typically present a heat load of 146
PARTICULATE LIMITS
The LF 6600 is designed for use in an office or computer room. The environment must have a low dust level. The LF 6600 filters incoming air for cooling to reduce the quantity of particles entering the drive; however, the filter is not effective against small particles (including tobacco smoke) which will become deposited on optical components and media, causing degradation in drive performance. Refer to the Operator Maintenance section for media cleaning and air filter cleaning instructions.
PLASMON LASER MAGNETIC STORAGE - LF 6600 User Manual Page 20