Sanyo VCC-6594 instruction manual Line phase adjustment

Page 18

L53H4/US (VCC-6594) GB 2001, 11, 9

SETTINGS

Line phase adjustment

When using a camera switcher to connect 2 cameras or more to one monitor, there may be a vertical roll of the images when switched. In such a case, set as described below.

1Set the switch 9 (SYNC) to the up (LL) position.

2Switch the display on the monitor from camera 1 to camera 2. Adjust the LINE PHASE volume on camera 2 until the vertical roll of the image stops.

If more than two cameras are used, please repeat this procedure for all the cameras.

CAUTION:

If the vertical roll cannot be corrected by setting the LINE PHASE volume on camera 2, try setting the LINE PHASE volume on camera

1.If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct.

English 15

Image 18

Contents Color CCD Camera About this manualExclusions Plummer Street Contents AccessoriesFeatures Information to User For the customers in CanadaPour la clientèle canadienne Precautions Power input terminal Video output connector Video OUT BNC typeLine phase adjustment volume Line Phase Power indicator PowerHole 1/4-20 UNC Lens mount capLens iris output connector Lens Camera setup section under the coverDC type auto-iris lens If using a Video type auto-iris lensConcerning AUTO-IRIS Lenses Video type auto-iris lensRemove the lens mount cap from the camera Mounting the LensCheck the lens mount Mount type lensRewiring the lens cable in the lens iris plug Flange-back adjustmentConnections Coaxial cable type and maximum lengthSettings Table a switch 1 ~ 60AI 100 500 1000 2000 4000 Electronic shutter settings and electronic iris settingsAutomatic Gain Control AGC setting ApertureBacklight compensation setting This camera has two different backlightWhite balance adjustment Lens iris adjustmentLine phase adjustment Troubleshooting No picture on the monitor screenPicture is not clear Specifications