Sanyo VCC-6570P instruction manual External sync adjustment VBS, Lens iris adjustment

Page 16

SETTINGS

External sync adjustment (VBS)

1Connect the VBS signal output for the other camera to the VBS IN connector at the rear of this camera.

2If the signals are not synchronized, change the sub-carrier (SC-P1) switches as follows.

Setting

9-pin

10-pin

Default

OFF (down)

OFF

 

 

 

Set to 90˚ counterclockwise

OFF

ON (up)

Set to 180˚ counterclockwise

ON

OFF

 

 

 

Set to 270˚ counterclockwise

ON

ON

 

 

 

Lens iris adjustment

If using a DC type auto-iris lens, you will need to set the LEVEL (VR301) volume when shooting in the conditions described below.

VR301

LEVEL

L (counterclockwise): To decrease the contrast

H (clockwise): To increase the contrast

• If shooting simultaneously in a dark room and through a bright

window.

H-P

Note:

VR304

9

10

 

•

If the subject background is extremely bright or dark.

•

If the brightness of the picture on the monitor is not correct.

•The sub-carrier switches let you make broad adjustments to the sub-carrier phase. If finer adjustments are required, contact the place of purchase.

•The type and length of the cable which is connected to the VBS connector may cause the horizontal synchronization being out of phase. If this happens, adjust VR304 (H-P: horizontal sync).

English 15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents About this manual Über diese BedienungsanleitungAccessories ContentsFeatures Precautions Power indicator Power Video output connector Video OUT BNC typeLine phase adjustment volume Line Phase C OUT connector 4 pinHole 1/4-20 UNC Parts NamesLens mount cap Lens iris output connector Lens Camera setup section under the coverIf using a Video type auto-iris lens Concerning AUTO-IRIS LensesDC type auto-iris lens Video type auto-iris lensMounting the Lens Check the lens mountRemove the lens mount cap from the camera Mount type lensFlange-back adjustment Rewiring the lens cable in the lens iris plugMounting the Lens Connections Coaxial cable type and maximum lengthConnections to the camera Y/C OUT connector ConnectionsSettings Settings High speed electronic shutter settingIris function setting Table a switch 1 ~ 120 250 500 1000 2000 4000 10000Backlight compensation setting This camera has two different backlightSynchronization settings White balance adjustmentLine phase adjustment External sync adjustment VBS Lens iris adjustmentNo picture on the monitor screen TroubleshootingPicture is not clear Specifications CameraSpecifications Dimensions1AC6P1P2453 L53T5/XE 0801KPS-DSP
Top Page Image Contents