Sanyo VCC-6570P Parts Names, Power indicator Power, Video output connector Video OUT BNC type

PARTS NAMES

15 2

3

4

6

12

34

1Power indicator (POWER)

Comes on when the power to the camera is on.

2Video output connector (VIDEO OUT: BNC type)

Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector.

3AC power cord

4External sync composite video signal input connector (VBS IN: BNC type)

Connect to this connector the synchronizing signal output from a synchronizing signal device or the composite signal of a video distributor.

5Line phase adjustment volume (LINE PHASE)

When using two cameras or more, the image on the monitor may roll vertically when switching sources. This rolling can be minimized by turning this volume.

6Y/C OUT connector (4 pin)

Separate Y (luminance) and C (chroma) signals are output from this terminal.

A better picture quality is obtained if the monitor or VCR is connected to this connector.

1 Y signal ground 2 C signal ground

3Y signal: 1.0 Vp-p, 75 ohms, unbalanced, negative sync

4C signal: 0.3 Vp-p, 75 ohms, unbalanced

English 3