Amana XRSR687BW, XRSS687BB Control Features, Ice Dispenser Operation, Dispenser Lock, Auto Light

Dispenser Features

Control Features

(Five button control)

Ice Dispenser Operation

To dispense ice:

• Select Cubed or Crushed ice mode by pushing button on dispenser control panel. A green indicator light above button shows mode selection.

• Press container against dispenser pad. When dispensing crushed ice, hold container as close

to chute as possible to reduce spraying. Selection mode may not be changed while ice dispenser is in operation.

NOTE: If dispenser is active for more than 3 minutes, an automatic lock out sensor will shut down power to dispenser area. See Automatic Lock Out for further information.

Dispenser Lock

This feature prevents ice or water from being dispensed.

To lock and unlock dispenser:

•To lock dispenser, press and hold Dispenser Lock button for 3 seconds. A green indicator light above button confirms dispenser is locked.

•To unlock dispenser, hold Dispenser Lock button for 3 seconds. Green indicator light above button will go out.

What is the Automatic Lock Out feature?

The Automatic Lock Out feature shuts down power to the water and ice dispenser when either dispenser has run continuously for approximately 3 minutes. If this mode goes into effect, the green light will activate above the Dispenser Lock button.

To unlock dispenser:

•To unlock dispenser, hold Dispenser Lock button for 3 seconds. Green indicator light above button will go out.

Filter Status Indicator Light

The Filter Status Indicator Light serves as a reminder to replace the water filter. A green light indicates that the filter is in good condition. A red light indicates the filter should be changed. Once light turns red, it will remain red until function is reset.

To reset indicator:

•Press and hold both Dispenser Lock and Auto Light buttons simultaneously for 4 seconds. The green Filter Status Indicator Light will flash 3 times when the function has successfully reset.

Auto Light

The Auto Light function offers the ability to activate the dispenser light at half-power when the Light Sensor detects that the light levels in room are low.

To activate and deactivate Auto Light:

•To activate, press Auto Light button located on control panel. A green indicator light above button displays to show that sensor is active.

•To deactivate, press Auto Light button. Green indicator light will go out.

NOTE: Dispenser light will operate whether or not Auto Light is selected.

Sabbath Mode (some models)

This mode is intended to deactivate power to the LED and dispenser lights,	+
while allowing the controls to remain operational.
To activate Sabbath Mode:	NOTE: In the event that power is
	interrupted while the Sabbath Mode
• Press and hold both Dispenser Lock and Auto Light buttons simultaneously
	is active, the control will remain in
for 3 to 4 seconds. After 3 to 4 seconds, the LED and dispenser lights will turn
	Sabbath Mode when power returns.
off. Dispenser light will not activate during dispensing while in this mode.

To deactivate Sabbath Mode:

•Press and hold both Dispenser Lock and Auto Light buttons simultaneously for 3 to 4 seconds. After 3 to 4 seconds, the LED and dispenser lights will activate.

15