Amana XRSS687BB, XRSS267BB Freezer Features, Primary Features, Automatic Dispensing Ice Maker

Freezer Features

What if These Features are Different from Mine?

Primary Features

This book is intended to show the variety of features that are available in the product line. If your refrigerator does not have all the options that are shown, many of these options may be purchased by contacting your local distributor.

! CAUTION

To avoid property damage, observe the following:

•Do not force ice maker arm down or up.

•Do not place or store anything in ice storage bin.

Automatic Dispensing Ice Maker

This ice maker creates the ice used in the dispensing system.

Using Ice Maker for the First Time

•Confirm ice bin is in place and ice maker arm is down.

• After freezer section reaches between -18° to -17° C, ice maker fills with water and begins operating.

•Allow approximately 24 hours

after installation to receive first harvest of ice.

•Discard ice created within first 12 hours of operation to verify system is flushed of impurities.

Operating Instructions

•Confirm ice bin is in place and ice maker arm is down.

•After freezer section reaches -18° to -17° C, ice maker fills with water and

begins operating. You will have a complete harvest of ice approximately every 3 hours.

• Stop ice production by raising ice maker arm until click is heard.

•Ice maker will remain in the off position until arm is pushed down.

IMPORTANT: Ice Cream Shelf should not be installed if ice maker arm is in “off” position

Ice Cream Shelf

The Ice Cream Shelf provides a space for items to be chilled or frozen quickly.

• To remove, lift Ice Cream Shelf from ice bin rails and pull straight out.

• To install, reverse above procedure.

IMPORTANT: Ice Cream Shelf should not be installed if ice maker arm is in “off” position

Ice Storage Bin

The ice storage bin is located below the automatic dispensing ice maker.

To remove and install ice storage bin:

• To remove bin, remove Ice Cream Shelf. Raise ice maker arm to deactivate ice maker.

•Lift front of bin and pull out to its full extension. Lift up front of bin and remove.

•To install, slide bin into rails below ice maker until bin locks into place. Drop ice maker arm to activate ice maker, and replace Ice Cream Shelf.

IMPORTANT: Ice bin must be locked in proper place for proper ice dispensing. If freezer door does not close, bin is not

in proper location. Turn auger driver as shown to properly alignice bin with back of unit.

12