Amana XRSS267BB, XRSS687BB How to Install and Remove Handles, Installing Your Refrigerator

Installing Your Refrigerator

How to Install and Remove Handles

Handles are located within fresh food section of refrigerator. Trim, plugs, and accent pieces will be located within the literature assembly.

Full-Length Grab Handles (non-stainless steel)

1 Remove two 1/4" hex nut screws from bottom of refrigerator

and freezer door.

2 Align door handles with top and bottom sets of door clips, and slide down until screw holes on bottom of handles match with door screw holes.

3 Insert screws removed in step 1 into screw holes at bottom of handle section.

4 Snap trim over bottom portion of handles and retainers on bottom of door

To remove after initial install...

•Follow steps 3 through 4 in reverse order.

NOTE: Fit may be tight. When removing handle, pull up and out.

Half-Length Grab Handles (non-stainless steel)

1 Remove four 1/4" hex nut screws from top and bottom of doors.

2 Align door handles with screw holes and insert screws removed in step 1.

3 Snap colored handle trim over screw holes at top and bottom of handles.

• Snap in trim by inserting large round end first.

To remove after initial install...

Handles may need to be removed if transporting unit through tight spaces.

•Follow steps 2 and 3 in reverse order.

IMPORTANT: To avoid damage to handle, use a flat blade screwdriver edge wrapped in masking tape to remove colored handle trim.

!WARNING

To avoid risk of serious personal injury from sharp edges, use extreme caution when removing & installing handles.

Stainless Steel Models

1 Loosen lower door clip on refrigerator door with 1/4" hex nut driver.

2 Locate predrilled hole at base of handle, and fit hollow end of handle over lower door clip.

3 Fit other end of handle over upper door clip and slide up as far as possible.

4 Insert 1/4" hex nut driver into predrilled hole at base of handle and tighten screw.

5