Powering the Camcorder
Caution: Do not attempt to use a “power converter” to use your AC adapter/charger on a power source other than 120 volts, 50/60 Hz, or the adapter/charger and camcorder may be damaged. If you wish to operate the AC adapter/charger on a power source other than 120 volts, 50/60 Hz, use only a
will damage your AC adapter/charger. An optional CPS014 shown on page 53 is
designed for use on
Using the Adapter/Charger to Power Your Camcorder
Plug in AC Outlet (120V, 50/60Hz)
Adapter/Charger
BATTERY
POWER
CHARGE
POWER
Indicator
DC | Adapter/Charger’s |
| |
OUTPUT | DC IN 9.6V Jack | ||
DC Cable | |||
Jack | |||
|
|
1.Connect one end of the adapter/ charger’s cable to the adapter/ charger’s DC OUTPUT jack and the other end to the DC IN 9.6V jack on the back of the camcorder.
2.Plug the adapter/charger into the nearest AC outlet (120V, 50/60 Hz).
3.The POWER indicator on the adapter/charger will light when it is properly connected.
Notes: The adapter/charger cannot charge the battery and operate the camcorder at the same time. If you connect both, the adapter/charger will power the camcorder. Remove the adapter/charger’s cable from the DC OUTPUT jack to charge the battery.
When using the adapter/charger to power the camcorder, the battery level indicator
may display . This indicator is used for battery operation and has no meaning when using the adapter/charger to power the camcorder.
To Remove the Adapter/Charger
1.Remove the adapter/charger’s plug from the AC outlet.
2.Remove the adapter/charger’s DC cable from the DC IN 9.6V jack on the camcorder.
Caution: Do not use this adapter/charger for any purpose other than charging the EP096FS, EP096FL, CB096FS, or CB096FL battery pack or supplying power to the camcorder.
10