Final System Check

USB Video Diagnostic - If live video is not displayed on the PC monitor of the Acclaim System when the streaming video capture software application is running, there could be a problem with the settings in the software application or with the camera system.

Perform the USB Video Diagnostic procedure to check the following:

❑The camera and the USB 2.0 interface control module of the USB Umbilical are working correctly.

❑The USB Umbilical is correctly connected between the camera and the computer

❑The camera USB driver files are installed correctly on the PC.

Conduct the USB Video Diagnostic by performing procedure the following steps.

1.Go to the Start button and select Programs.

2.Select the Acclaim program option and click on AMCAP and observe that the AMCAP screen opens.

3.On the AMCAP screen, click DEVICES on the menu bar along the top of the screen and make sure that ACCLAIM USB ONLY CAMERA is selected from the drop down list.

4.Click OPTIONS on the menu bar along the top of the AMCAP screen and make sure that PREVIEW is selected from the drop down list.

5.Depending on the outcome of the USB Video Diagnostic, perform one of the following:

a.If a live image is correctly displayed, exit from AMCAP application and make sure that the streaming video capture software application is configured correctly.

b.If a live image is not displayed, exit from AMCAP application and check the camera, USB Umbilical and USB driver file installation.

c.If a live image is displayed but the image colors are not correct, reset the driver's video settings by performing the procedures of step 6.

6.Reset the driver's video settings by performing the following:

a.On the AMCAP screen, click OPTIONS on the menu bar along the top of the screen and select VIDEO CAPTURE FILTER from the drop down list.

b.On the Properties screen select the VIDEO PROC AMP tab and then click the DEFAULT button. The image colors should now be correct. Click OK to close the Properties screen and exit from AMCAP application.