Yamaha AVX-S80 owner manual Preparation Steps, Installing batteries in the remote control P.3

PREPARATION STEPS

In order to enjoy sound and video images with this sound system, follow the procedures as described below. See each page for details.

Installing batteries in the remote control (P.3)

Speaker setup (P.9)

•Speaker placement (P.9)

•Installing the speakers (P.10)

Connections (P.12 – 17)

•Connecting TV and audio/video components (P.12)

•Connecting the antennas (P.14)

•Connecting the speakers (P.15)

•Connecting the AC power cord (P.17)

•Turning on the power (P.17)

Adjusting speaker output levels (P.18)

Before connecting components

•Do not connect this system or other components to the mains power until all connections between the components have been completed.

•Be sure all connections are made correctly, that is to say, L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. Some components require different connection methods and have different jack names. Refer to the operation instructions for each component to be connected to this system.

•Insert the plugs properly. The speakers may not output any sound or may output noise if they are not inserted properly.

•The name of jack corresponds to input selector.

•The VOLTAGE SELECTOR on the rear panel of AVR- S80 and SW-S80 must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110-120V/220-240V AC, 50/60 Hz. (China, Korean and General models only)

AVR-S80 (General model)

VOLTAGE
SELECTOR
110 – 120V	220 – 240V

VOLTAGE SELECTOR

SW-S80 (General model)

220V–240V

II0V–I20V

VOLTAGE

SELECTOR

After connecting components

•Check them again to make sure they are correct.

8